CATHEREEPLUS™ ROLL type. It can be cut to the required length for use.
Product information compliant with
EU Medical Device Regulation (EU MDR)
Overview
Non-sterile product
3 additional care considerations
"Gentle to the skin" and "good adhesion" were difficult to achieve with conventional adhesives due to their conflicting properties.
CATHEREEPLUS™ ROLL uses an urethane gel adhesive that has a very high moisture permeability, so it "gentle to the skin" and "good adhesion" were achieved at a high level.
We propose a "new fixation" that adds three compassions of "high moisture permeability", "high adhesion" and "low skin irritation".
Usage
- Fixing covers for gauze and dressings
- Fixing tubes and catheters
- Protective covering for the skin
- For those who are using the stoma or CAPD, to reinforce and protect the brace when showering.
Features
High moisture permeability makes your skin always smooth.
The urethane gel adhesive has a moisture permeability that is approximately 5 times higher than general acrylic adhesives (compared to our company). It keeps your skin comfortable even after a long period of application because it reduces stuffiness caused by sweating.
Since it adheres firmly, it can be used with confidence.
Since the urethane gel adhesive is coated evenly on the entire surface of the film, the gel adhesive adheres firmly to the unevenness of the skin. Because the film is flexible, it follows the movement of the skin and adheres well even if it is applied for a long time.
Low irritation and gentle to the skin
The urethane gel adhesive
hardly peels or damages the stratum corneum
when peeling. The film stretches well, reducing stress on the skin. Reduces rash and pain when peeling.
- The release film is "pre-lifted", so it is easy to handle even with gloves.
- As it is an elastic film, it is easy to apply and reduces stress on the skin.
- The product prevents water and bacteria from entering from outside.
- Excellent slipperiness reduces friction with clothing and sheets.
Directions
-
1
Pull out to the required length and cut off with scissors.
-
2
Remove the release liner in the center part from the lead part (cut line).
-
3
Hold the remaining release liner edge and apply the product in place.
-
4
Peel off any remaining release liner and press down firmly on the product.
-
5
Slowly peel off the release film from the edge indicated by arrows.
-
6
Slowly peel off the remaining piece of release film.
Precautions
- Do not use directly on a wound or puncture site because this product is not sterile.
- Do not use on areas with an infection, bleeding, exudate, skin disorders, or abnormal skin metabolism.
- This product cannot be used as a substitute for fixation sutures.
- Thoroughly wipe the skin and check that it is clean and dry prior to application.
- Do not apply with the product extended, as it may cause skin damage and peeling.
- Discontinue use if a skin disorder or other abnormality occurs.
- If it is clinically determined that the infection has occurred, discontinue use, take appropriate treatment, and resume use after the infection has cleared.
- Before showering or bathing, make sure that the product is in full contact with your skin and brace.
- When removing, peel off slowly along the flow of the body hair to prevent skin damage.
Storage Instructions
- Storage method: Store at room temperature, away from water, high temperatures, high humidity and direct sunlight.
Specifications
| Product number | Size | Per box |
|---|---|---|
| CPSR0510 | 50mm x 10m | 1 roll |
| CPSR1010 | 100mm x 10m | 1 roll |
| CPSR1510 | 150mm x 10m | 1 roll |
